Soda Tab Bracelet

Soda Tab Bracelet

Materials:


-Lots of soda tabs
-Ribbons, shoe lace, strings
-Scissors 
-Glue (optional)


1.Gather all the materials.

2.Now get your string, ribbon, or w.e. it is that you will use to thread threw the soda tabs for this project, and cut to the length you want. I didn't measure at all =)... but it seem like 1' or a bit more.

3.After cutting the length you desire line them up and tie a knot.

Like so

4.Get 2 soda tab and you will see that it has 2 different sides, a rough and a flat surface, now the rough surfaces should be facing each other for this, like so:

5.Now thread one, the flat surface should be up now and grab the ribbon and thread it from the top...from the flat part, on both holes.

6.Now get the other tab and do the same but this tab should be facing the opposite of the 1st tab. 

7.You will be doing step 5 & 6 until you get the desire length of this bracelet.

8.Now when you get to the desired length you will tie a know like in the beginning. 

*For this side i sewed it cuz i like it very secure, i left in between the know about 1/2"

9.For the beginning of the bracelet i added a soda tab so i can use it as a "lock" and put it threw the end, like so:

Now show your project off!!! Happy Crafting!